PLUNGE SAWING

Concrete cutting with plunge saw at Ruskin Dam, Canada.

 

When the backside of a cut cannot be directly accessed, we configure a plunge saw to make the cut.  Plunge saws run a continuous wire loop through multi drive wheels.  Watch a plunge saw in action.  The technicians move the saws into position by first core drilling access holes.  The saw drops into the holes, and the cut is made by pushing the wire down between the holes.   This push cutting technology requires fewer set ups than commonly used methods, thereby increasing efficiency.  A classic example is the Ruskin Dam job, where we used plunge saws to cut stairsteps up the slope of a hydroelectric dam.
 

 

Contact Us

Our experts are available to provide a quote or discuss your project. We have delivered creative concrete and metal cutting solutions since 1979, and welcome the opportunity to assist you.

Request A Quote

Safety

The Bluegrass culture promotes a safety first attitude. On job sites our technicians are prepared, aware, equipped and committed to safe practices.

Read More

Resources

We mobilize a full spectrum of resources to deliver prompt, successful results: highly trained personnel, dependable equipment, diamond wire saws, robotic hammers, a machine shop and more.

Learn More

FAQ

If your question is not answered here, contact us to discuss your project. Our experienced staff is prepared to provide solutions to any metal and concrete demolition challenge.

Learn More